GOLD 95/115/130 OWNER’S MANUAL VER 10
©
Copyright by
FLY
Products
srl
Page
15
of thermal soaring, and then when he gets low, re-start the engine pressing the START button and climb
back up to do it again
WARNING!
It's very important that immediately after landing, or when the equipment is not in use on
the ground, to turn the main security switch to the OFF position to avoid an accidental starting of the
engine with unpredictables results!
Carburetor Adjusting
To adjust the idling, turn the screw shown in Fig
The screw sets the revs at idle, by opening or closing
the butterfly valve
Choke lever is used only for cold engine starting, do
not leave it “ON” for long time to avoid a flooded
engine
Carburetor
WALBRO WB 37
Carburetor Adjusting
Standard carburetor setting
When purchased, the motor has a standard carburetor setting and testing. To modify, this one must adjust
the two screws of the carburetor. The screw on the right marked with a
L
(low) regulates the entrance of
fuel at the low speed (the range of the accelerator from zero to half).
The screw on the left marked
H
(high) regulates the air fuel mix higher speeds.
It is extremely important to both maximum engine efficiency and engine life, to understand and keep in
tune your carburetor setting.
There are two fuel to air carb setting which function in the following manner:
L
screw adjust: rotate (clockwise until completely closed).
