GMI-ROT Series - Absolute Rotary Encoder
User Manual
●
The manufacturer of the final system in which the
ENCODER
will be incorporated must
comply with all current regulations regarding the grounding of the system and verify the
correct execution at the end of the installation.
●
Make sure that no injuries or material damage can occur due to the rotating elements.
●
Follow the installation procedure reported on the dedicated technical data sheets
attached to this document, according to the specific
ENCODER
configuration.
●
Install the
ENCODER
in applications that ensure compliance with the technical
specifications shown on the dedicated technical data sheet attached to this document,
according to the specific
ENCODER
configuration.
●
Install the
ENCODER
in applications that ensure compliance with the mounting
tolerances, according to the specific
ENCODER
configuration.
●
Install the
ENCODER
in applications that ensure compliance with the electrical data,
according to the specific
ENCODER
configuration.
●
Install the
ENCODER
in applications that ensure compliance with the maximum
mechanical speed, according to the specific
ENCODER
configuration.
●
Do not use the conduits as protective conductors, but a protective conductor inside the
conduit.
●
The cross-section of the protective conductor must comply with the standards in force.
Do not consider cable shields to be equivalent to a protective conductor.
●
Prevent foreign bodies from getting inside the product.
●
Check that the gaskets and cable glands are correctly seated in order to prevent
pollution due, for example, to sedimentation and humidity.
●
Do not touch unprotected components or live parts.
●
Carry out the assembly (using screws with adequate tightening torque) so that the
ENCODER
does not come off even in the event of strong acceleration or repeated
shocks.
●
Each system in which the
ENCODER
is used must be subjected to a risk assessment
and an accurate functional check before operation.
●
Do not use the
ENCODER
as a load-bearing element.
●
Protect the pipes of the connections to the energy sources by means of rigid sheaths or
suitable cable ducts.
●
Do not place the
ENCODER
in the immediate vicinity of very hot surfaces, flammable or
heat sensitive components.
●
Perform the required interventions using standard work tools and paying the utmost
attention to elements that could lead to stumbling or causing cuts and bruises.
●
The
ENCODER
cannot be used until the
ENCODER
itself is tested: the presence of any
assembly or installation error could lead, in fact, to serious accidents for the operators.
FLUX GmbH - Austria
2022-04, rev00
18/34
