6
TS90 Cable Fault Finder
Users Guide
Always handle the clip leads and the cables by
their insulation, NEVER directly by the
conductive wire. Use only the insulated clips
provided to connect to any wire or cable.
W
Caution
Use only line cords approved by Fluke
Networks. Other cords may cause incorrect
measurements.
Legal requirements may exist regarding
permission to connect equipment to a Telecom
network operated by a public network
operator.
Installing Batteries
The tester uses 4 AA batteries (included). Install the batteries
in the battery compartment on the back of the tester.
W
Warning
X
To avoid electric shock, disconnect measuring
terminals before opening the battery door.
To remove the battery door, push the plastic tab in the
direction of the arrow and lift off the door. Observe correct
polarity when inserting the batteries. The polarity is marked
on the inside of the battery compartment. Reinstall the
battery door before connecting the tester to anything.
Note
To extend battery life, remove batteries when the
tester is not in use.
