Fluke PRUFTECHNIK ROTALIGN touchEX, Manual

Page: 64 / 166

Extend measurement range manually
Measurement range may be extended manually in Multipoint and Static measurement modes.
This range extension allows the adjustment of the laser beam such that it does not miss the
detector surface when measuring shafts with gross misalignment or angular misalignment
over large distances. During measurement, manual extension is prompted by accessing the XY
view before 'Laser End' is displayed.
l
If the laser dot ( 1 )on the display continues to move further away from the center of the
detector screen while rotating shafts to take measurements using Multipoint meas-
urement mode, tap the detector area (
2 ) to access the "XY view" screen.
l
After accessing the "XY view", use the two yellow laser horizontal and vertical position
thumbwheels and adjust the laser dots such that they are positioned inside or very close
to the square targets.
Note
During the laser adjustment procedure, avoid readjusting the sensor.
ROTALIGN touch EX 63
On-board help