M E D T E S T E R 5 0 0 0 C F I E L D U P G R A D E I N S T A L L A T I O N I N S T R U C T I O N S
10
7.
To install more than one module, repeat steps seven (7) through nine
(9) for each module which has an installation disk. Install them in
numerical order.
8.
If necessary, return to Windows from Command Prompt by typing:
EXIT<Enter>
at the DOS prompt.
Confirming Module Installation
1.
Turn the medTester 5000 power off to reset the microprocessor.
2.
Turn the medTester 5000 power on. Check that the startup message
shows the correct instrument serial number and the correct firmware
version number.
3.
Push
F5 UTIL
, then right arrow, then
F3 MODULES
. At this point, each
press of
F5 NEXT
will sequentially scroll through each installed module
allowing you to confirm the modules installed in the medTester 5000.
Summary of Contents for Network Device MedTester 5000C
Page 2: ......
