63/66/68
Infrared Thermometers
20
mode. It can be used when the thermometer has any number of
log locations stored.
Note
Only use the LOG Clear function if you want to clear all
the LOG location data that is stored in the unit’s memory.
To use LOG Clear, while in LOG mode, pull the trigger then press
until the unit reaches LOG location “0”.
Note
This can only be done when the trigger is pulled. LOG
location “0” cannot be accessed by using
.
When LOG location “0” shows in the display’s lower left corner,
press
. Three tones sound and the LOG location automatically
changes to “1”, signifying that all data locations have been cleared.
Maintenance
Changing the Battery
To install or change the 9 V battery, open the unit and attach the
battery to the battery snaps with the positive side facing toward the
rear of the battery compartment. See Figure 2.
Cleaning the Lens
Blow off loose particles using clean compressed air. Carefully wipe
the surface with a moist cotton swab. The swab may be moistened
with water.
Cleaning the Housing
Use soap and water on a damp sponge or soft cloth.
W
Caution
To avoid damaging the thermometers, do NOT
submerge them in water.
