Fluke 5020A, User Manual

Page: 42 / 142

5020A
Users Manual
5-6
Sensor Lock
The SENSOR LOCK function locks each sensor individually and prohibits the user from
switching sensors on the locked channels. This may be password-protected. The sensor
lock is set to ON or OFF. After selecting ON, a screen is displayed showing the sensor
channel number, serial number, and the message ‘NOW LOCKED’. When the sensor
lock is ON, the thermo-hygrometer measures only on that channel using the sensor that
was attached when sensor lock was set ON. This can be used to prevent inadvertent
attachment of an uncalibrated sensor or one that is not in the desired location. It uses the
sensor serial number to identify the sensor. To exchange a different sensor, the sensor
lock must be set to OFF.
avu007.jpg
Figure 5-6. Sensor Lock
Use the
A D
buttons to select the sensor to lock. The
B C
buttons are used to select ON
or OFF. Press the
E
button to save the setting and exit. Press the
F
button to cancel
any changes and exit to the menu.
Sensor Cal
The SENSOR CAL function allows the sensor parameters to be edited. This function is
always password-protected. If an incorrect password or no password is entered, the
parameters are displayed but cannot be edited. If a correct password is entered, the
channel, sensor model, sensor serial number, and sensor ID are displayed. Select the
sensor channel of the parameters to edit and then select the
E
button. The sensor
parameters are displayed for editing.
Caution
The sensor calibration parameters are critical to the accuracy of
the sensor. Do not change them.
The
B C
buttons are used to select a channel. Press the
E
button to save the setting and
exit. Press the
F
button to cancel any changes and exit to the menu.