Medical ScopeMeter
Memory and PC
47
USB Drivers
To communicate, the test tool requires USB driver installation on your computer. Windows 10 and
later automatically recognizes the test tool and uses the drivers supplied by Windows. No special
drivers are required. Windows activates these drivers the first time you connect the test tool. An
admin account and active Internet connection may be required to allow Windows to load the
latest drivers.
After you install the drivers, an additional
USB Composite Device
shows in the
Windows Device
Manager, Universal Serial Bus Controllers
section. At this point, you are ready to use
FlukeView 2 software through the USB connection.
Next to the USB device is also a
USB Serial Device (COM 3)
that shows in the
Windows Device
Manager Ports
section. This Com port is for calibration purpose.
Note
The COM port number may differ and is automatically assigned by Windows.
Save and Recall
The test tool can:
•
Save screens and setups to internal memory, and recall them again from memory. The test
tool has 30 screen and setup memories, 10 record and setup memories, and 9 screen image
memories. See
•
Save up to 256 screens and setups to a USB memory device, and recall them again from
memory.
•
Name saved screens and setups according to your own preferences.
•
Recall screens and recordings to analyze the screen image at a later date.
•
Recall a setup to continue a measurement with the recalled operating configuration.
