Page 6
FW-F014-P-M_v0402_05_EN.docx
2.3
OPERATOR INFORMATION AND FUNCTIONS
In general, the F014-P will always function at Operator level. The information displayed is dependent
upon the SETUP-settings. The signal from the connected sensor is processed by the F014-P in the
background, whichever screen refresh rate setting is chosen. After pressing a key, the display will be
updated very quickly during a 30 second period, after which it will slow-down again.
Fig. 3: Example of display information during process.
For the Operator, the following functions are available:
•
Display flowrate / total or Flowrate
This is the main display information of the F014-P. After selecting any other information, it will
always return to this main display automatically.
Total is displayed on the upper-line of the display and flowrate on the bottom line.
It is possible to display flowrate only with the large 17mm digits; in this instance press the
SELECT-key to read the total.
When "-------" is shown, then the flowrate value is too high to be displayed. The arrows
indicate the increase/decrease of the flowrate trend.
•
Clear total
The value for total can be re-initialized. To do so, press CLEAR twice. After pressing CLEAR
once, the flashing text "PUSH CLEAR" is displayed. To avoid re-initialization at this stage, press
another key than CLEAR or wait for 20 seconds.
Re-initialization of total DOES NOT influence the accumulated total.
•
Display accumulated total
When the SELECT-key is pressed, total and accumulated total are displayed. The accumulated
total cannot be re-initialized. The value will count up to 99,999,999,999. The unit and number of
decimals are displayed according to the configuration settings for total.
Fig. 4: Example of low-battery alarm.
•
Alarm 01-03
When "alarm" is displayed, please consult Appendix B: problem solving.
R
U
N
