MN310125 Rev A2
25
|
Wiring
Step Five
WIRING DIAGRAM - SAMPLE
WIRING ECHOPOD
®
Once EchoPod
®
has been configured; follow the Wiring Diagram provided by the WebCal
®
software. A typical
wiring diagram is shown above. Flowline recommends using a qualified licensed electrician to wire EchoPod
®
with your application’s components.
Configure your EchoPod
®
with WebCal
®
and use the wiring diagram button to view the appropriate
diagram. Each configuration will have its own unique diagram. The diagram shown above is only a
sample and should not be used as a wiring diagram.
EchoPod
®
is a loop powered 4-20mA device. The power loop and current output loop are shared by
the Red and Black wires.
Relays are all dry contacts so polarity can be revered from the example shown in the wiring diagram.
Always use stepper relays between the sensor and external loads. For DC circuits, always use a catch
diode such as 1N4148, shown on the Wiring diagram above supplied by WebCal
®
.
Once EchoPod
®
is configured, isolate the white and green wires from active power to prevent a
short of the configuration circuit.
Sample Wiring Diagram
Diagram will change based upon
the sensor’s configuration, use
WebCal
®
to view appropriate wiring
diagram.
