DataView™ LI55 Level Controller
Quick Start
21
| P a g e
Setting the SCALE Function (
SCALE
)
The DataView displays information about
tank contents in engineering units. The
display uses a two point linearization
based upon Empty and Full settings.
Although
a
signal
source is not needed
to scale the meter
, you will need to
configure the sensor connected to the
display to reflect a 4-20 mA current span
between tank empty and tank full.
Enter the value you wish an Empty tank to
show when empty and the value a Full
tank to show when full. These are the corresponding Empty (EmPtY)
and Full (FuLL) settings.
To set the SCALE fucntion:
1. Press
the
MENU
button to enter the Main Menu. Units (unitS) will
be the first operation available.
2. Press
the
Up
button to scroll through the menu options until you
reach Scale (SCALE).
3. Press
ENTER
button to enter the Scale.
a. Empty (EmPtY) will appear.
4. Press
the
ENTER
button to change the Empty value. This is
typically the value seen when the tank is empty. Press the
Right
button to move the highlighted digit to the right and the
Up
button to
increase the setting’s value.
5. Press
the
ENTER
button to save the settings.
a. Full
(FuLL)
will
appear.
6. Press
the
ENTER
button again to change Full value. This is
typically the value seen when the tank is full. Press the
Right
button to move the highlighted digit to the right and the
Up
button to
increase the setting’s value.
7. Press
the
ENTER
button again to save the settings.
8. Press
the
MENU
button to exit.
