DataView™ LI55 Level Controller
Quick Start
16
| P a g e
Setup and Configuration
This section will take you through the 6 key steps in setting up and
programming the DataView (some configurations of DataView will not
use all 6 steps).
1. Select and set Units of operation (unitS)
a. This step determines the units of operation for the display.
b. The value that appears on the display will reflect the
choice of units.
c. The actual units can configured to appear in the lower
display (LIttLE).
2. Setting the decimal point (dEc Pt)
a. This step determines the location of the decimal point.
b. For example, you can configure the display to read to
1/10th position, 1/100th position, 1/1000th position, etc.
3. Setting the SCALE function (SCALE)
a. This step configures the display to read in the actual units
of operation.
4. Setting the Relay(s) (rELAY)
a. This step configures the relays and where they will
energize and de-energize.
b. This step is only available with configurations that include
relays: (LI55-_201, LI55-_211, LI55-_401 or LI55-_411).
5. Setting the Analog Output (Aout)
a. This step configures the analog output for the display.
b. The step is only available with configurations that include
the repeater output (LI55-_011, LI55-_211 & LI55-_411).
6. Password (Pass 1)
a. Sets a protective password to secure the settings for the
display.
