FLORABEST FHL 900 D4, Translation Of The Original Instructions

Page: 28 / 44

28
GB
• Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
• Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
into account the working condi-
tions and the work to be per-
formed. Use of the power tool for op-
erations different from those intended
could result in a hazardous situation. •
Carefully inspect the area to be cut
and remove all wires or other foreign
bodies.
• Prior to every use, check the appliance
for obvious defects such as loose, worn
or damaged parts.
Service
• Have your power tool serviced
by a qualified repair person us -
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
Hedge trimmer safety
warnings
• Keep all parts of the body away from
the cutter blade. Do not remove cut
material or hold material to be cut
when blades are moving. Make sure
the switch is off when clearing jammed
material. A moment of inattention
while operating the hedge trimmer
may result in serious personal injury.
• Carry the hedge trimmer by the handle
with the cutter blade stopped. When
transporting or storing the hedge trim-
mer always fit the cutting device cover.
Proper handling of the hedge trimmer
will reduce possible personal injury from
the cutter blades.
• Keep cable away from cutting area.
During operation the cable may be
hidden in shrubs and can be acci-
dentally cut by the blade. If dropped,
check the equipment for significant
damage or defects.
Assembling the
Long-Handled Hedge
Trimmer
Pull out the power plug before car-
rying out any work on the equip-
ment.
Use only original parts.
1. Unpack the device and check it
for completeness.
B
2. Remove the covering cap (21)
from the front extension arm (8).
Push the front extension arm of
the long-handled hedge trimmer
on to the tubular shaft of the
long-handled hedge trimmer
with a slight twisting motion. The
safety button (9) locks into place.
Fix the two tubular elements in
place with the rotary knob (10).
To do this, unscrew the nut of
the threaded rod of the rotary
knob (10) and insert it sideways
into the retainer of the tubular
shaft. Insert the threaded rod of
the rotary knob (10) through the
tubular shaft and screw on the
rotary knob (10) with the nut.