Floorpul C150 U13 ERG, Operation And Maintenance

Page: 23 / 112

EN
EN - 3
1.1 TECHNICAL
CHARACTERISTICS
Voltage ................................................230 V
Frequency ...........................................50 Hz
Motor power .....................................1300 W
Working width..................................505 mm
........................................................ 20 inch.
Rotation speed .............................1500 rpm
Weight without accessories................. 44Kg
Electrical cable length ..........................15m
Sound level ..................................<70 dB(A)
Vibration level........................................<2.5
Working pressure .........0 - 5 Kg (adjustable)
Transmission type ............................... direct
Maximum dimensions
................................1130 x 790 x 330H mm
Minimum dimensions
..................................855 x 790 x 485H mm
1.2 INTRODUCTION
DANGER:
Before using the appliance, read the accompa-
nying “SINGLE DISC SAFETY WARNINGS”
booklet carefully.
This manual forms an integral part of the ma-
chine itself. It must therefore be kept in a safe
place where it is accessible to all users (opera-
tors and maintenance personnel) throughout
the life of the machine until it is scrapped.
1.3 - INTENDED USE OF
THE MACHINE
The machine has been designed and built:
for polishing floors that have been cleaned
and vacuumed beforehand (i.e. parquet,
marble, ceramic, linoleum etc.).
DANGER:
Any other use releases the manufacturer
from liability for harm to persons and/or
property and invalidates any warranty
condition.
1.4 - NON-INTENDED USE
OF THE MACHINE
WARNING:
The machine is not intended for outdoor
use.
DANGER:
- do not polish uneven floors;
- do not use on cement floors;
- do not use on dirty floors;
- do not use diesel/petrol or corrosive de-
tergents to polish floors;
- do not polish if corrosive, flammable and/
or explosive liquids, even if diluted, are
present.
2.1 UNPACKING
(Figs. 1-2)
Upon delivery of the machine, remove its ex-
ternal packaging and cut the straps (1) (Fig.
1) and lift up the handle (2) by pulling on the
release handle (3) (Fig. 2).
2.2 COMPONENT
ASSEMBLY
2.2.a - Assembling the cable reel
supports (Figs. 3/5)
The reel supports supplied must be mounted
directly on the handle shaft:
- Fit the short coupling (4) into the long
coupling (5) (Fig. 3).
- Tighten the knob (6) on the screw (7),
keeping the latter to the right (Fig. 4).
- The hook (8) of the support can be ro-
tated depending on usage (Fig. 5).
- Place one support on the top of the han-
dle and a second support on the bottom.