page 21
Manual MK23 V 1_09 Z33
Contents
Special codes for MK23 pedal calibration using the SKF Mode:
Hold down the black key Ped Cal gis'''' (G#7) and enter code for:
right pedal / damper / sustain
501
middle pedal / sostenuto
504
left pedal / soft
502
Aux 3
503
Aux 4
505
Factory setting FLK dual pedal
until May 2014
510
Factory setting FLK triple pedal
and new FLK dual pedal June 2014
511
resets
ALL
pedal calibrations to factory settings. (0 – 127 equals ~2 to 10
kOhm). User calibration data will be deleted!
Default
516
E
XAMPLE
:
Push
MODE
and
ON
simultaneously > Hold down “Ped Cal” (g#4) > Enter the required code >
Release “Ped Cal” (g#4) > Ascending melody for confirmation
The minimum and maximum position of your pedal will be automatically measured and saved when
quitting the SKF Mode by pressing
Mode
.
Hint:
We recommend pushing the pedals by hand when calibrating as the results will be more accurate, especially if
you only want to calibrate part of the travel range.
Instructions:
Push the pedal to the required minimum. After you let go “Ped Cal” (g#4) the current position is stored as zero
point. Push the pedal now slowly to the desired end setting and hold this position. Store it by pushing
MODE.
This also exits SKF Mode
.
Attention: The longest travel range within a calibration session is stored. Calibrating the pedal again overrides
previous stored values.
Almost any conventional pedal can be used with your FLK. (It may be helpful to use a Y stereo to
mono splitter).
