432-0003-00-10 rev 140 M-Series Operator’s Manual
25
JCU Power Menu
Camera
”. This indicates the user can scroll down with the puck to select a
camera to control. When the desired camera name is shown in the display,
press the puck to select that camera. The camera name will blink momen-
tarily to indicate the camera has been selected.
JCU Stndby?
When the “
JCU
Stndby?” option is selected, the display momentarily shows
“
Goodbye
” and then the backlit controls and the display are turned off. The
JCU buttons and puck will no longer control the camera. The Power/DIM
button remains backlit as long as power is supplied to the JCU. To power up
the JCU again, press and hold the Power/DIM button.
Camera Stndby?
When the “
Camera Stndby?
” option is selected, the camera will move to
the stowed (parked) position and the camera will go into the Standby state.
Generally the stowed position is with the ball rotated down so the camera
optics are in a protected position. The Stow position can be configured with
the on-screen configuration menus.
The JCU display will prompt the user to select a camera to control. If the
same camera is selected, the camera will return to the Powered On mode.
System Stndby?
If the “
System Stndby?
” option is selected, both the JCU and camera are
powered off, as described above.
Global Stndby?
Global standby is a command sent by a JCU that will power down all discov-
ered cameras and JCUs. This function is used to properly shutdown all cam-
eras (return to stow position) and JCUs prior to removing power with the
system breaker.
Selecting
“Global Stndby?”
directs the JCU to command all
JCUs and cameras found on the network to go to standby mode. Global standby
can also be achieved by pressing the SCENE, COLOR, and HOME buttons in uni-
son for three seconds.
Calibrate JCU
The “
Calibrate JCU
” function is used to calibrate the JCU puck. This func-
tion might be used for example if the camera responds at a different rate
when the puck is pushed left rather than right, or when the puck is twisted
in one direction compared to the other. The JCU display directs the user to
move and twist the puck in certain ways so the device can be calibrated.
When calibrating, you will be instructed to move the puck to the maximum
extent possible in each direction separately. After that has been done,
pressing the puck moves to the next step. For example, "Rotate CW/CCW"
requires rotating the puck CW to the full extent possible, and then rotating
Summary of Contents for M-Series
