System Startup
20
432-0003-00-10 rev 140 M-Series Operator’s Manual
Troubleshooting Tip
:
if the JCU does not have power, it may be connected
to a Power over Ethernet (PoE) switch which has not been powered on, or it
may be connected to a network switch that does not provide PoE power.
Bootup Mode
The following section describes what happens when the circuit breaker is
energized and power is applied to the camera. The camera will stay in the
Bootup state for approximately 55 seconds. During the bootup process,
the bootup screen and messages are displayed on the monitor, followed by
live video, which is displayed only momentarily, until the camera goes into
standyby mode..
Initially the FLIR splash screen will appear, as shown to the left. Then
another splash screen with two important notices will appear:
Warning:
Do not use the M-Series imaging system as the primary naviga-
tion system. Use it in conjunction with a primary navigation system and
other navigation aids.
Note
:
The M-Series IR Thermal Imaging System is an Export Controlled
item. Authorization by the U.S. Government must be obtained prior to
export outside the United States.
After the splash screens are displayed, the video screen will show a mes-
sage that says “
Loading, please wait...
”
1
When the bootup is com-
plete, the monitor will briefly show live video, and then the display will be
blank, to indicate the camera is in Standby mode. The gimbal assembly
Summary of Contents for M-Series
