FT-13 Technical Manual, Rev. 1.40 March 2013
Page 29 of 56
7.4 Target and Preset Entry
TARGET and TOLERANCE ENTRY
+
Press F and N keys sequentially.
Target message and it‟s value are shown alternately.
To edit the value use the numeric keys and press <Enter>.
+ / - tolerances of filling or discharging are shown. The
value entered here shall alarm the operator.
To edit the value use the numeric keys and press <Enter>
to return to the operation mode.
To disable the tolerance control, enter “0”.
PRESET VALUES ( CUT-OFF ) ENTRY
+
Press <F> and <P> keys sequentially to enter the coarse
lead in value.
To edit the value use the numeric keys and press the
<Enter> key.
Coarse lead-in = Target
– Coarse cut off (see figure 7.1)
The mid-feed lead-in value is shown on the display if 3-
speed feeding is enabled.
To edit the value use the numeric keys and press the
<Enter> key.
Mid-feed lead-in = Target
– Mid-feed cut off
The fine lead-in value is shown on the display.
To edit the value use the numeric keys and press <Enter>
to return to the operation mode.
Fine lead in = Target
– Fine cut off (see figure 7.1)
Attention:
Changing the target value does not require a change of the coarse lead-in and fine lead-in values in
general.
Warning:
For accurate filling the coarse lead-in and fine lead-in values must be choosen carefully.
MiddLE
XXXXX
tARGEt
XXXXX
toL
XXXXX
CoArSE
XXXXX
FınE
XXXXX
