FT-13 Technical Manual, Rev. 1.40 March 2013
Page 27 of 56
At the end of the filling cycle the filling machine waits for
the
d_End
delay time to release the clamp.
“
Gr-NET
” defines whether the filling will be done:
0 = Gross Filling without zeroing
1 = Gross Filling with zeroing (related with par.[50E])
2 = Net filling
Enter the value which will start the vibration.
Enter the value which stops the vibration which was started
at [vibon].
Exit
Process Messages
Description
This message is displayed until the clamp is activated.
This message is displayed until the detecting clamp switch
after the clamp output is activated. FT-13 waits for the clamp
switch input for 5 seconds. If the input is not set within 5 s
the
“clamp position error“ will be set.
This message is displayed during the automatic zeroing
cycle after the cycle start, if applicable.
This message is displayed at the end of the Filling for d_End
delay time.
7.3.9 Programme 8: Bag filling from hopper scale
Operation:
This filling mode controls filling machines which have
one weighing hopper and a bag catcher.
The process starts with the start input and
continues automatically, if the start input is active.
After the start input is set, the system waits for
catching the bag to remove the residual material in
the weighing hopper. After removing this material
filling starts automatically.
The weighing hopper is filled to the target value
accurately and then it will be emptied to the bag
when the following bag is clamped.
The machine operation stops after deactivating the
start input and filling the last bag. The weighing
hopper will be emptied after stopping the
automatic operation.
StArt
XXXXX
FULL
hoLd
- Zero -
XXXXXX
viboFF
XXXXXX
vibon
X
Gr-Net
XX.X
d_End
