14 English
7.7 Reset the lock with a pin (add a new programming card)
(See 11.2 Advanced troubleshooting.) After resetting the lock
with a pin, it will remain in the same mode as before.
The old programming card is erased. Any user or service
cards will also be erased.
1.
Turn the lock over and insert the activation pin in the
socket on the back, hold down for about 3 seconds.
The programming signal will sound for about 7 seconds.
2. Place the new programming card onto the lock before the
7 seconds are up. A confirmation signal will sound
and the new programming card is now registered to the lock.
3. Program the Service Card. See point 4.2.5-4.2.6.
8 Battery changing
When the battery is low, a warning signal will sound when locking
and also
a beeping sound when open/close. This signal will sound more often as the battery level decreases,
from every 6 hours. If the battery isn’t changed, the lock will automatically open and stay open.
Use a a lithium battery recommended by Swedstyle AB (of the type CR123A, 3V, min 1400 mAh).
1.
Detach the battery flap with a
torx 10 screwdriver.
2. Change the battery – make sure the battery
poles are the right way around.
Battery expiration date should be at least
5 years away.
NOTE!
Do not close the storage until the function of the battery is verified.
If the battery is missing or broken, you might not be able to open the lock again.
Test the lock with the front open!
We recommend a scheduled battery change, for every third year or maximum after 30 000
openings. Do not wait for the battery warning as a routine procedure.
!
Programming
Programming
7 SEC
