72
How to replace battery at the hose handle
1)
Use a small fl at screwdriver and place
it between the hose handle and the
recess at the keypad. Then gently bend
with the screwdriver so that the pad
loosen from the hose handle.
2)
Lift up the keypad from the hose
handle.
The battery is placed in a bracket at
the underside of the keypad. Loosen
the battery from its bracket by using
hand power.
Replace the used battery with a new
one, type 3V CR2.
Make sure the polarity of the battery
are placed correct at the bracket.
3)
Reassemble the keypad with the new
battery to the hose handle by gently
pushing the pad into the handle.Then
push the keypad downwards to that it
snaps in place at the hose handle.
INSTRUCTION FOR
USE
The on-off function and power
regulaton is controlled by radio
technology. You do not have to
point at the machine like infra-
red controls. The RRC bent end
can be used anywhere in the
house.
Start and stop
Start: One push at the switch=will start the cleaner.
Stop: One push at the switch with in 30 minutes from start - will shut
off the cleaner.
The power regulation can be adjusted in 3 steps, Min., medium
and max you switch between the different steps by pressing the (+)
or (-) buttons at the hose handle. After 30 minutes of permanent
operation, the machine will shut itself off. This as a safety action if
the cleaner have started unintentionally. Another safety action is that
the battery power in the hose handle will be shot down if some of
the buttons at handle will be pushed down for more then 8 seconds.
This in order to prevent the battery from being discharged.
LED-indicator
The LED-indicator that are placed at the on/off button will be activated
with different lights depending of the actions that are taken:
Green fi xed light= activated at start or stop actions or when
the power regulation are adjusted.
Yellow fl ashing light= warning light that indicates that the bag
fi lter/dustbag are clogged and needs cleaning/replacement.
Indication in handle once speed has been adjusted (+) or (-) or on/off.
You must then check and clean or replace the fi lter/bag. Then push at
the reset button at the display of the cleaner, for at least 3 seconds in
order to switch off the yellow warning light at the hose handle/display
Battery
The lifetime of the enclosed batteries in the bent end, is
approximately fi ve (5) years. If the battery capacity at operation
start is to low, the cleaner will then be shut off. If the cleaner would
not start or the power regulation via the hose handle do not work,
you must replace the battery at the hose handle. Replace to new
battery type 3V CR2. For more information and trouble shooting
see chapter 10 in this instruction for use.
1
2
12 RADIO REMOTE CONTROL CV 400 RRC
WARNING!
Do not pull out the suction hose from the cleaner while the
motor/fan unit of the cleaner is running.
These machines have a safety shut off function.
This shut off function will be activated when the machine is
operated with a closed vacuum socket.
NOTE! BEFORE THE FIRST OPERATION
An antenna is enclosed with the RRC machine. But in needs
to be fi xed at the central vacuum cleaner. It is fi xed simply by
tighten the antenna at the matching spiral socket in the lid. See
the illustrations below:
On/Off
Power
regu
Power regulation -
LED-
indicator
The first transmission
The hose handle and the cleaner needs to have a fi rst com-
munication before starting the cleaner. This is also valid if
the hose handle have been replaced (spare part). Do like
this before starting your RRC-cleaner:
1
) Unplug the main cord.
2)
Then plug in the cord again, and at the same time
push at the on/off button at the hose handle for
10
seconds.
3)
The handle and the cleaner do now communicate.
EN
Summary of Contents for CV 100
Page 73: ...73 ...
Page 74: ...74 ...
Page 75: ...75 ...
Page 76: ...Flexit AS Televeien 15 N 1870 Ørje Norway www flexit no ...
