66
7 Filter and dust bags - CV 200 / CV 300 / CV 400 RRC
7.3 Replacing the dust bag
The machine is supplied with a paper dust bag.
Replace the dust bag in the following way:
1. Release the two handles clamped on to the dust con-
tainer. Free them by pulling the handles outwards away
from the container.
2. Lift off the container.
3. Shake the dust from the bag fi lter. It may be advan-
tageous for the fi lter to be installed in the container in
such a way that dust in the fi lter can be shaken down
into the dust container.
4. Lift out the bag fi lter.
5. Remove the old dust bag by turning the cardboard stif-
fener to the right or left so that the raised part of the inlet
is in line with the opening in the card. Carefully pull out
the card, Fig. 23. Fold down the perforated part of the
cardboard towards the opening of the bag in order to
prevent the bag contents to leak out.
6. Empty the container of dust.
7.1 Replacing of the bag fi lter
A bag fi lter must always be installed in the dust container.
Clean the fi lter in the following way:
1. Release the two handles clamping the dust container.
Free them by pulling the handles outwards away from
the container, Fig 20.
2. Do not remove the fi lter from the container. Instead, give
the fi lter a light shaking inside the container to loosen
dust from the fi lter allowing it to fall into the container,
Fig. 21.
3. Lift out the bag fi lter. If a dust bag is being used - remo-
ve the dust bag. Then empty the container of any remai-
ning dust in a suitable place.
7.2 Fitting the bag fi lter
Replace the bag fi lter in the machine as follows:
1. Replace the cleaned/shaken bag fi lter in the container,
Fig. 22. Make sure the fi lter support fi ts into the inner
edge of the dust container properly. Check that the fi lter
is fi tted the right way up - the cloth handle on the fi lter
should be visible.
2. Then replace the dust container with the bag fi lter in the
cleaner’s vacuum unit.
3. Close the container on the vacuum unit by applying in-
ward pressure to the two handles to ensure the vacuum
unit and dust container are fi tted together properly.
7.4 Fitting the dust bag
Replace the dust bag as follows:
1. Push the opening in the cardboard over the elevation on
the inlet and pull on the new bag. Turn the cardboard to
lock the bag in place, Fig. 24.
2. Replace the cleaned/shaken bag fi lter in the container.
Make sure the fi lter support fi ts into the inner edge of
the dust container properly.
Check that the fi lter is fi tted the right way up - the cloth
handle on the fi lter should be visible, Fig. 22.
3. Replace the dust container on the vacuum unit. Close
the container on the vacuum unit by applying inward
pressure to the two handles to ensure the vacuum unit
and dust container are fi tted together properly.
4. Replace the inlet socket in the machine.
The CV 200 / CV 300 / CV 400 RRC can be run with or wit-
hout the installation of a dust bag - the choice is yours, but it
is recommended that you install a dust bag. These products
must always be operated with a bag fi lter fi tted.
Fig. 20
Fig. 21
Fig. 22
Fig. 23
Fig. 24
EN
Summary of Contents for CV 100
Page 73: ...73 ...
Page 74: ...74 ...
Page 75: ...75 ...
Page 76: ...Flexit AS Televeien 15 N 1870 Ørje Norway www flexit no ...
