63
4.1 Replacing the dust bag
The central vacuum cleaner is fi tted with a paper dust bag
as standard; never vacuum without a dust bag installed.
Grasp the edge of the lid and pull upwards to open it, Fig. 10.
Replacing the dust bag: Remove the old dust bag by tur-
ning the cardboard stiffener to the right or left so that the
raised part of the inlet is in line with the opening in the card.
Now slide the bag off the bag nozzle.
Fit the new dust bag as follows: Push the opening in the
cardboard over the elevation on the inlet and pull on the
new bag. Turn the cardboard to lock the bag in place. NB!
Turn the edges of the dust bag down into the container.
This is to avoid damaging the bag with the lid.
The cardboard stiffener locks the bag in place when you
twist it as shown in Fig. 11 above.
The opening in the card must line up and slide over the ele-
vation on the inlet before you twist the cardboard stiffener
to lock it.
4.2 Replacing / cleaning the fi lter
Open the lid and take out the dust bag as described earlier.
The fi lter sits at the bottom of the container around the mo-
tor housing. Never use the central vacuum cleaner without
a fi lter installed.
Pull the fi lter out of the container, Fig. 12. The fi lter can be
cleaned by shaking it or washing it in water.
If you wash the fi lter, you must let it dry completely before
refi tting it.
Take the cleaned fi lter and place it in the bottom of the con-
tainer. Press the outer edge of the fi lter down against the
sides of the container so that the fi lter bulges up slightly.
Then push the fi lter down into place. Make sure the fi lter
is packed in tightly against the motor housing, Fig. 13.
Reinstall the dust bag and replace the lid. Check that the
lid is fi rmly secured.
4 Filter and dust bags - CV 100
Filter
Filter
Motor housing
Fig. 13
Fig. 11
Fig. 12
Fig. 10
EN
Summary of Contents for CV 100
Page 73: ...73 ...
Page 74: ...74 ...
Page 75: ...75 ...
Page 76: ...Flexit AS Televeien 15 N 1870 Ørje Norway www flexit no ...
