Flexit CV 100, Assembly Instructions And User Manual

Page: 62 / 76

62
3.1 Starting the machine
The control current outlet (low voltage) should be connec-
ted to a control current lead running the length of the pipes.
Both ends of the low-voltage lead should be connected to
the connection panel on the vacuum cleaner. One lead to
each outlet.
The central vacuum cleaner’s power cable must be con-
nected to a 230 volt mains socket. The appliance is double-
insulated and does not need to be earthed.
The vacuum cleaner starts and stops automatically. When
the vacuum hose is connected to a vacuum socket, a metal
ring on the end of the hose closes the control circuit and
the vacuum cleaner starts up. 7. When the hose is remo-
ved from the vacuum socket, the vacuum cleaner stops.
You should allow the hose to empty of dust and dirt before
switching the vacuum cleaner off.
If you use a hose with an on-off switch, you can start
and stop the vacuum cleaner using the switch on the
handle, Fig. 8.
3.2 Servicing
Always unplug the power cord before doing any
service work!
If suction is poor, it indicates that the fl ow of air through the
machine is restricted. This may be due to the following:
• The dust bag is full and should be replaced.
• The
fi lter is clogged and should be cleaned.
The vacuum cleaner has a thermal cut-out that trips if the
vacuum cleaner becomes overheated. If this happens -
unplug the main power cord to reset the vacuum cleaner.
Wait 5-10 minutes to allow the machine to cool down.
While you are waiting, check the hose, dust bag and fi lter
to be sure that nothing is blocking the fl ow of air through
the machine. The vacuum cleaner should now start again.
If the cut-out trips again, you need to get a service fi rm to
remedy the fault.
The CV 100 should only be operated with a dust bag and
fi lter installed.
3 Operating instructions CV 100
1
2
Fig. 7
Fig. 9
Fig. 8
Filter
EN