17 SuperUser mode
FLUXUS F501
17.7 Manual reset of the totalizers
119
UMFLUXUS_F501V1-3EN, 2020-06-30
17.7
Manual reset of the totalizers
If the manual reset of the totalizers is activated, the totalizers can be reset to zero during the measurement by pressing
key C 3 times, even if a program code is activated.
• Select the menu item
Special Funct.\SYSTEM settings\Measuring\Miscellaneous
.
• Press ENTER until the menu item
3xC
clear totals
is displayed.
• Select
on
to activate the manual reset of the totalizers,
off
to deactivate it.
• Press ENTER.
17.8
Display of the totalizer sum
The totalizer sum of both flow directions can be displayed in the upper line during the measurement.
• Select the menu item
Special Funct.\SYSTEM settings\Measuring\Miscellaneous
.
• Press ENTER until the menu item
Show
ΣQ
is displayed.
• Select
on
to activate the display of the totalizer sum,
off
to deactivate it.
• Press ENTER.
If the display of the totalizer sum is activated, the sum
Σ
Q of the totalizers can be displayed in the upper line during the
measurement.
17.9
Display of the last valid measured value
If the signal is not sufficient for a measurement,
UNDEF
is normally displayed. Instead of UNDEF, it is also possible to dis
-
play the last valid measured value.
• Select the menu item
Special Funct.\SYSTEM settings\Measuring\Miscellaneous
.
• Press ENTER until the menu item
Keep display val
is displayed.
• Select
on
to activate the display of the last valid measured value,
off
to deactivate it.
• Press ENTER.
Special Funct.\SYSTEM settings\Measuring\Miscellaneous\3xC clear totals
Notice!
The manual reset of the totalizers is still activated after the deactivation of the SuperUser mode.
Special Funct.\SYSTEM settings\Measuring\Miscellaneous\Show ΣQ
Fig. 17.2: Display of the totalizer sum
Special Funct.\SYSTEM settings\Measuring\Miscellaneous\Keep display val
ΣQ
13.2 m3