FLUXUS ADM 8027, F801, ADM 8127B
10 Start-Up of the Transmitter
72
UMFLUXUS_F8V4-6-1EN, 2018-10-10
10
Start-Up of the Transmitter
10.1
Switching on
10.2
Initialization
During an initialization (INIT) of the transmitter, the settings in the program branches
Parameter
and
Output Options
and some of the settings in the program branch
Special Funct.
are reset to the default settings of the manufacturer.
For INIT-resistant settings, see annex A.
Proceed as follows to execute an initialization:
• While switching on the transmitter: keep keys BRK and CLR pressed.
• During the operation of the transmitter: press keys BRK, CLR and ENTER at the same time. A RESET is executed. Re-
lease only key ENTER. Keep keys BRK and CLR pressed.
After the initialization, the remaining settings of the transmitter can be reset to the default settings and/or the stored mea-
sured values can be deleted.
10.3
Display
10.3.1
Main Menu
The selected program branch is displayed in capital letters between arrows. The complete designation of the selected pro-
gram branch is displayed in the lower line.
Select a program branch with key
and
. Press ENTER.
As soon as the transmitter is connected to the power supply, the serial number of the trans-
mitter is displayed for a short time.
It is not possible to enter any data while the serial number is displayed.
Afterwards, the main menu is displayed in the default language. The language of the dis-
play can be set (see section 10.5).
After the initialization has been executed, the message
INITIALISATION DONE
is dis-
played.
Select
yes
to reset the remaining settings to the default settings or
no
to keep them at the
current settings.
Press ENTER.
If
yes
is selected, the message
FACTORY DEFAULT
DONE
will be displayed.
Select
yes
to delete the stored measured values or
no
to keep them stored.
Press ENTER.
This display will only be indicated if measured values are stored in the data logger.
The main menu contains the following program branches:
•
par
(Parameter)
•
mea
(Measuring)
•
opt
(Output Options)
•
sf
(Special Functions)
Note!
By pressing key BRK, the measurement is stopped and the main menu is selected.
Note!
In this user manual, all program entries and keys are indicated with typewriter characters (
Parame-
ter
). The menu items are separated from the main menu by a backslash "\".
FLEXIM FLUXUS
X80X
-XXXXXXXX
>PAR<mea opt sf
Parameter
INITIALISATION
----DONE----
FACTORY DEFAULT?
no
>YES<
Delete Meas.Val.
no
>YES<
>PAR< mea opt sf
Parameter
