OPERATION MANUAL
FLEXESERVE HUB®
FLEXESERVE® | Operation Manual Flexeserve Hub® | V1 AUG 2020 | 40002982
Page | 10 of 22
Positioning
WARNING
Installation of these units should be carried out by appropriately qualified and skilled
personnel. Failure to do so may result in unsafe operation or personal injury.
WARNING
Adequate provision should be made for lifting and positioning the unit to avoid risk of
damage or injury. Sufficient personnel should be available to handle each unit without
contravening company or site health and safety policies.
It is recommended that a minimum of two persons are required for placing the equipment into position.
The equipment must be kept in the vertical orientation at all times.
A gap of at least 50mm (2 inches) should be left between the back of the equipment and any wall/solid
surface.
Once the unit is placed in the desired location, it should be prevented from being moved.
The Flexeserve Hub® models have castor brakes fitted that should be applied. The castor brakes are
located to the front elevation of the unit, as shown in the illustration below.
Moving
Before moving the unit, isolate and disconnect the power cord from the wall socket. Stow the electrical
power cord so that it does not become damaged during repositioning.
The units are not suited to pass over ledges or obstacles. Make sure that the wheels can move freely and
never come into contact with the power cord (see figure below).
Front counter elevation
showing front brake castors
Plug
Wall socket
