1/4/2021
REV. 002
20
3.
Insert the Size 2 alignment plug into the quick-change chuck (
Figure14)
.
4.
Move the arm to the vertical surface (perpendicular to the surface the arm is mounted) you are
tapping and secure it to the surface via the magnetic plug. Tighten only the rear handle that fastens
through the front side plates of the arm (
Figure 13
)
. Leave the handle on the tapping head (
Figure 12
)
loose. This will allow the tap to follow the hole in as it taps the hole.
5.
Before you pull the magnetic plug away, make sure it is flush with the tapping surface. Once the plug is
removed, make sure the tap is going to easily follow the hole you are tapping.
Figure 14
Summary of Contents for FLEXARM RNR
