Flex S 47 M, Manual

Page: 20 / 214

20
English
Î Put the disposal bag over.
Î Pull the opening of the disposal bag out
toward the back over the suction sup-
port.
Î Tightly seal the disposal bag with clo-
sure strips underneath the opening.
Î Dispose of the disposal bag according
to the local provisions.
Î Release and remove the suction head.
Î Clean the electrodes.
Î Insert and lock the suction head.
Note
In case of a failure (e.g. filter breakage) the
appliance must be turned off immediately.
The failure must be remedied before the
appliance is put into operation again.
Î Check cables, plugs, fuse, socket and
electrodes.
Î Turn on the appliance.
Î Empty the container.
Î Turn off the appliance and wait for 5
seconds, turn it on again after 5 sec-
onds.
Î Clean the electrodes as well as the
space between the electrodes.
Î Remove blockages in the suction noz-
zle, suction tube, suction hose, or flat
pleated filter.
Î Replace the dust disposal bag paper fil-
ter bag (special attachment).
Î Ensure the filter cover properly locks
into place.
Î Replace the flat pleated filter.
Î
Check for proper installation of the flat
pleated filter.
Î Replace the flat pleated filter.
Î Clean the electrodes as well as the
space between the electrodes.
Î Continuously check the filling level in
case of non-conductive liquid.
Î Suction hose is not connected.
Î Inform Customer Service
Î Inform Customer Service
Dust disposal bag
Cleaning the electrodes
Troubleshooting
Suction turbine does not run
Suction turbine turns off
Suction turbine does not start again
after the container has been emp-
tied
Suction capacity decreases
Dust comes out while vacuuming
Automatic shut-off (wet vacuum
cleaning) does not react
Automatic filter cleaning is not
working
Automatic filter cleaning cannot be
switched off
Automatic filter cleaning cannot be
switched on