INSTALLATION INSTRUCTIONS
HOSEDOWN SERIES
IMPORTANT:
READ ALL INSTRUCTIONS THOUROUGHLY AND CAREFULLY PRIOR TO INSTALLATION OF
ESSENTIALS SERIES FIXTURES AND RETAIN FOR FUTURE REFERENCE.
FLEXLIGHTINGSOLUTIONS.COM
913.851.3000
REV 082318
ADJUSTMENTS
THREE TRIMPOTS ON THE FM-105 ALLOW YOU TO ADJUST THE TIME DELAY, SENSITIVITY/RANGE, AND LIGHT LEVEL SETPOINT. TO REDUCE A SETTING,
TURN THE ASSOCIATED TRIMPOT COUNTER-CLOCKWISE TOWARD THE MINIMUM SETTING. TO INCREASE A SETTING, TURN THE TRIMPOT CLOCKWISE
TOWARD THE MAXIMUM SETTING.
WARNING: DO NOT OVERTURN THE ADJUSTMENT TRIMPOTS!
TIME DELAY
THE FM-105 AUTOMATICALLY TURNS
OFF
THE LOAD AFTER THE COVERAGE AREA HAS BEEN VACANT FOR THE AMOUNT OF TIME SET IN THE TIME DELAY.
THE MINIMUM SETTING IS 10 SECONDS, MAXIMUM IS 30 MINUTES.
RANGE/SENSITIVITY
IT IS POSSIBLE FOR A HIGH FREQUENCY SENS
OR TO “SEE” THROUGH
SOLID OBJECTS AND DETECT MOTION IF THE SENSITIVITY IS SET TOO HIGH. IF YOU
ARE GETTING DETECTIONS AND THE LOAD WILL NOT TURN
OFF
, REDUCE THE SENSITIVITY SLIGHTLY AND SEE IF THAT CORRECTS THE SITUATION.
LIGHT LEVEL
ADJUST THE DAYLIGHTING SETPOINT WHEN AMBIENT LIGHT IS SUFFICIENT TO KEEP THE LIGHTS
OFF
. SET THE TIME DELAY TO MINIMUM. ADJUST THE
LIGHT LEVEL TRIMPOT IN SMALL INCREMENTS. WAIT 1 TO 2 MINUTES BETWEEN ADJUSTMENTS. AFTER THE TIME DELAY EXPIRES AND THE LOAD TURNS
OFF
, MOVE WITHIN THE DETECTION AREA OF THE SENSOR. IF THE LOAD COMES BACK
ON
, YOU NEED TO REPEAT THE PROCEDURE.
IMPORTANT STARTUP INFORMATION
THE FIRST TIME THE SENSOR IS POWERED-UP, THE LOAD WILL FLASH
ON
THEN
OFF
ONCE, THEN THERE WILL BE 10 SECONDS WHILE THE SENSOR
WARMS-UP. AFTER THAT TIME, THE SENSOR WILL WORK NORMALLY.
TROUBLESHOOTING
TO QUICKLY TEST THE UNIT, TURN THE TIME DELAY TO MINIMUM. MOVE OUT OF THE SENSOR
’S VIEW. LIGHTS SHOU
LD TURN
OFF
AFTER 10 SECONDS.
MOVE
INTO THE SENSOR’S VI
EW. THE LIGHTS SHOULD TURN
ON
.
LIGHTS DO NOT TURN ON:
1. COVER THE SENSOR TO SIMULATE DARKNESS THEN MOVE IN THE COVERAGE AREA. IF THE LOAD TURNS
ON
, ADJUST THE LIGHT LEVEL.
2. CHECK ALL WIRE CONNECTIONS. VERIFY ALL WIRES ARE SECURE.
LIGHTS DO NOT TURN OFF:
1. IF THERE IS NO MOTION IN THE DESIRED COVERAGE AREA, THE SENSOR MAY BE PICKING UP MOVEMENT ON THE OTHER SIDE OF A WALL, PARTITION,
WINDOW OR DOOR. REDUCE THE SENSITIVITY.
2. VERIFY TIME DELAY AND THAT THERE IS NO MOVEMENT WITHIN THE S
ENSOR’S VIEW FOR
THAT TIME PERIOD.
FCC NOTICE
FCC ID: Q4BFM105
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
CAUTION:
ANY CHANGES OR MODIFICATIONS TO THIS DEVICE NOT EXPLICITLY APPROVED BY WATTSTOPPER COULD VOID YOUR AUTHORITY TO OPERATE
THIS EQUIPMENT.
NOTICE:
THE FM-105 MAY CAUSE INTERFERENCE TO A NEARBY WIRELESS NETWORK OPERATING AT A SIMILAR FREQUENCY, AROUND 5.8 GHZ.
