Flex innovations Cessna 170 60E G2, Instruction Manual, Page: 8 / 28

7
HORIZONTAL STABILIZER INSTALLATION
Required Tools and Fasteners : Clear Tape (4 Strips) (1) M2x10 Phillips Head Machine Screw
#1 Phillips Screwdriver (2) M2 Flat Washer
Needle Nose Pliers (1) M2 Lock Nut
1. Insert the horizontal stabilizer tube into one of the horizontal stabilizer halves.
2. Slide the tube through the hole in the fuselage, being sure to orient the control horn towards the bottom of the airplane. Do not force it into
place.
3. Slide the other stabilizer half onto the tube, being sure to index the elevator joiner tabs into one another. Do not force it into place.
4. Apply 4 pieces of clear tape to the joint between the stabilizer and the plastic mounts. Be sure to apply tape to both the top and bottom sides
of the stabilizer.
5. Install the elevator pushrod ball-link in the control horn using the innermost hole as shown in the diagram below. Secure it using a #1 Phillips
screwdriver, needle nose pliers, and the following components:
(1) M2x10 Phillips Head Machine Screw
(2) M2 Flat Washer
(1) M2 Lock Nut.