FLEETWOOD RV BOUNDER, Owner'S Manual

Page: 24 / 97

LAMPS AND BULBS
Replace bulbs with the listed bulb or equivalent.
Interior - 12-volt
Bedroom/living room
reading lights ...............................1139IF, 12-volt
Bedroom soffit lights..................GE 5312, 12-volt
Dinette decor light........................GE 921, 12-volt
Round Halogen lights........................10W, 12-volt
Vanity light ....................................9019-F, 12-volt
Exterior
Back-up lights.............................GE 1156, 12-volt
Entry step light .............................GE 193, 12-volt
Front clearance lights.................GE 67DP, 12-volt
Front turn signal
lights................................................7440, 12-volt
Headlight, halogen
high beam ........................................HB3, 12-volt
Headlight, halogen
low beam .........................................HB4, 12-volt
License plate light ......................GE 5312, 12-volt
Mirror turn signal lights .............GE 1895, 12-volt
Porch lights ...........................Jensen 1003, 12-volt
Rear clearance lights ....................GE 193, 12-volt
Side marker lights.........................GE 194, 12-volt
Stop/turn/taillights ......................GE 1157, 12-volt
Driving Light.....................................HB4. 12-volt
Fog Light...........................................HB4, 12-volt
MOTOR HOME FUSES AND
CIRCUIT BREAKERS
The 120-volt circuit breakers and 12-volt fuses
are located on three separate panels. The pur-
pose of these three panels is to provide electrical
circuit breakers and fuses to interrupt current
flow if a circuit is overloaded.
1. 120-volt House Electrical — This electri-
cal panel is located under the bed. This
panel is very similar to a residential panel
with resettable breakers.
2. Fleetwood Automotive 12-volt System —
This panel is located in a driver's side com-
partment. This electrical center contains
battery disconnect systems, entry step, fog
light, and some other automotive circuitry.
3. 12-volt Chassis Fuses — This electrical
panel is located under the driver’s side
dash area.
CAUTION
Before relamping, disconnect power source by remov-
ing fuse or placing circuit breaker and control switch in
OFF position.
Halogen bulbs operate at extremely high temperatures
and pressures and will shatter if not handled correctly.
Always use a soft dry cloth or cotton gloves when han-
dling halogen bulbs.
Do not touch glass area with bare hands. If bulb is
touched with bare hands, wipe the bulb clean with rub-
bing alcohol.
Do not use near flammable or combustible materials
and/or objects which may be sensitive to fading or drying.
Use bulbs designed or specific by manufacturer as to
style, wattage and voltage.
SOUTHWIND INFORMATION
NOTE
Consult
Chassis Operator’s/Owner’s Guide/Manual
for automotive lamp replacement on chassis cab. This
would include headlamps, turn signals and running
lamps.
WARNING
Do not install 12-volt fuses or 120-volt breakers with
amperage ratings greater than that specified on the
device or label. Doing so constitutes a fire hazard.
!
04-7