FLEETWOOD RV BOUNDER, Owner'S Manual

Page: 20 / 97

LAMPS AND BULBS
Interior - 12-volt
Bathroom vanity light .......................13W, 12-volt
Bedroom decor lights .....................C-921, 12-volt
Bedroom reading light...................1139IF, 12-volt
Dinette decor light..........................C-921, 12-volt
Floor light.......................................GE 53, 12-volt
Living area decor light ...................C-921, 12-volt
Round Halogen Lights .....................10 W, 12-volt
Exterior
Back-up lights ............................GE 1057, 12-volt
Entry step light.............................GE 194, 12-volt
Front clearance lights...................GE 194, 12-volt
Front turn signal
lights ...................................Truck-Lite Model 44
Headlight, halogen
high/low beam..................Sylvania HB5, 12-volt
License plate light ..............................#53, 12-volt
Porch lights ...........................Jensen 1003, 12-volt
Rear clearance lights....................GE 194, 12-volt
Rear side marker lights...................Hamsar 99063
Rear turn signal lights................GE 7507, 12-volt
Side marker lights...........................Hamsar 99062
Stop/taillights .............................GE 1057, 12-volt
MOTOR HOME FUSES AND
CIRCUIT BREAKERS
The 120-volt circuit breakers and 12-volt fuses
are located on three separate panels. The pur-
pose of these three panels is to provide electrical
circuit breakers and fuses to interrupt current
flow if a circuit is overloaded.
1. 120-volt House Electrical — This electri-
cal panel is located under the bed. This
panel is very similar to a residential panel
with resettable breakers.
2. Fleetwood Automotive 12-volt System —
This panel is located in a driver's side com-
partment. This electrical center contains
battery disconnect systems, entry step, fog
light, and some other automotive circuitry.
3. 12-volt Chassis Fuses — This electrical
panel is located under the driver’s side
dash area.
CAUTION
Before relamping, disconnect power source by
removing fuse or placing circuit breaker and control
switch in OFF position.
Halogen bulbs operate at extremely high tempera-
tures and pressures and will shatter if not handled
correctly.
Always use a soft dry cloth or cotton gloves when
handling halogen bulbs.
Do not touch glass area with bare hands. If bulb is
touched with bare hands, wipe the bulb clean with
rubbing alcohol.
Do not use near flammable or combustible materials
and/or objects which may be sensitive to fading or
drying.
Use bulbs designed or specific by manufacturer as to
style, wattage and voltage.
PACE ARROW INFORMATION
04-1
NOTE
Consult
Chassis Operator’s/Owner’s Guide/Manual
for automotive lamp replacement on chassis cab. This
would include headlamps, turn signals and running
lamps.
WARNING
Do not install 12-volt fuses or 120-volt breakers with
amperage ratings greater than that specified on the
device or label. Doing so constitutes a fire hazard.
!