FLEETWOOD RV BOUNDER, Owner'S Manual

Page: 22 / 97

BOUNDER INFORMATION
LAMPS AND BULBS
Interior - 12-volt
Bedroom decor lights......................GE 1076, 12-volt
Bedroom/Living area lights ...............1139IF, 12-volt
Ceiling double incandescent ...........GE 1141, 12-volt
Ceiling single incandescent ............GE 1141, 12-volt
Driver/passenger map lights............MR 16C, 12-volt
Living area ceiling decor light..........GE 921, 12-volt
Living area decor light......................GE 921, 12-volt
Round Halogen Lights...........................10W, 12-volt
Vanity Lights .........................................9019, 12-volt
Wardrobe light ..................................GE 561, 12-volt
Exterior
Back-up lights .................................GE 1156, 12-volt
Entry step light..................................GE 194, 12-volt
Front clearance lights ...........................67DP, 12-volt
Front side markers/turn signal lights...Sylvania 3457,
12-volt
Headlight, halogen high-beam...HB3 (9005), 12-volt
Headlight, halogen low-beam.....HB4 (9006) 12-volt
High turn signal lamps...........Sylvania 3157, 12-volt
License plate light...............................GE 53, 12-volt
Porch lights .....................................GE 1003, 12-volt
Rear clearance lights.........................GE 194, 12-volt
Rear turn signal lights......................GE 1156 12-volt
Roadside Utility Light ....................GE 1156, 12-volt
Side marker lights.............................GE 194, 12-volt
Stop/turn/taillights...........................GE 1157, 12-volt
MOTOR HOME FUSES AND
CIRCUIT BREAKERS
The 120-volt circuit breakers and 12-volt fuses
are located on three separate panels. The pur-
pose of these three panels is to provide electrical
circuit breakers and fuses to interrupt current
flow if a circuit is overloaded.
1. 120-volt House Electrical — This electri-
cal panel is located in a cabinet at the foot
of the bed. This panel is very similar to a
residential panel with resettable breakers.
2. Fleetwood Automotive 12-volt System —
This panel is located in a side compartment
or engine access compartment. This electri-
cal center contains battery disconnect sys-
tems, entry step, fog light, and some other
automotive circuitry.
3. 12-volt Chassis Fuses — This electrical
panel is located under the driver’s side
dash area.
CAUTION
Before relamping, disconnect power source by remov-
ing fuse or placing circuit breaker and control switch in
OFF position.
Halogen bulbs operate at extremely high temperatures
and pressures and will shatter if not handled correctly.
Always use a soft dry cloth or cotton gloves when han-
dling halogen bulbs.
Do not touch glass area with bare hands. If bulb is
touched with bare hands, wipe the bulb clean with rub-
bing alcohol.
Do not use near flammable or combustible materials
and/or objects which may be sensitive to fading or drying.
Use bulbs designed or specific by manufacturer as to
style, wattage and voltage.
!
NOTE
Consult
Chassis Operator’s/Owner’s Guide/Manual
for automotive lamp replacement on chassis cab. This
would include headlamps, turn signals and running
lamps.
WARNING
Do not install 12-volt fuses or 120-volt breakers with
amperage ratings greater than that specified on the
device or label. Doing so constitutes a fire hazard.
!
04-3