36
NOTE:
YOUR HANDS SHOULD BE CLEANED
AND SANITIZED BEFORE YOU PERFORM
THE FOLLOWING PROCEDURES.
NOTE:
INSPECT ALL WEAR ITEMS AND
REPLACE IF NECESSARY.
NOTE:
THE FOLLOWING PROCEDURES
REQUIRE APPROVED, SERVICEABLE AND
SANITIZED TOOLS AND BRUSHES.
CONTACT YOUR LOCAL DISTRIBUTOR FOR
RECOMMENDED SUPPLIES.
NOTE:
USE AN APPROVED CLEANER AND
SANITIZER FOR THE FOLLOWING
PROCEDURES. REFER TO
MANUFACTURER’S INSTRUCTIONS FOR
PROPER PREPARATIONS OF THESE
CLEANING AGENTS.
NOTE:
THE SYSTEM IS NOT TO BE USED
BY PERONS (INCLUDING CHILDREN) WITH
REDUCED PHYSICAL, SENSORY OR
MENTAL CAPABILITIES, OR LACK OF
EXPERIENCE AND KNOWLEDGE, UNLESS
THEY HAVE BEEN GIVEN SUPERVISION OR
INSTRUCTION.
NOTE:
CHILDREN ARE TO BE SUPERVISED
WHEN USING THE SYSTEM AND SHALL
NOT PLAY WITH THE SYSTEM.
NOTE:
INSTALL THE SYSTEM WHERE
AMBIENT TEMPERATURES ARE BETWEEN
60 AND 80 DEGREES FAHRENHEIT FOR
CORRECT OPERATION.
NOTE:
INSTALL THE SYSTEM IN A
LOCATION WHERE ITS USE AND
MAINTENANCE IS RESTRICTED TO
TRAINED PERSONNEL.
Refer to your standard manual to perform these
Equipment Setup installations:
Installing the Spout Adapter
Installing the Touch Panel & Bracket
Spigot Switch Options
Installing the Spigot Switch
Sanitizing & Installing the Spout Assembly
Mounting the Casing Assemblies
Installing the Integrated Cabinet, Unit Syrup
Line, and Pump Harness Cable
The integrated cabinet is designed to be
installed inside the Taylor C201 mobile cabinet.
Included is a modified back panel that replaces
the Taylor cabinet back panel to accommodate
Flavor Burst’s tubing and electronics wiring.
Follow the instructions below to set up the
Flavor Burst cabinet and connections.
Ensure the inside of the C201 mobile cabinet is
clean and ready for installation.
The following instructions and illustrations are
consistent with a left-side mounting of the
Injector Assembly. This is recommended for
Taylor C707 / C708 freezer as this is the side
with the intake vents which help prevent heating
of the 9-Tube Assembly. However, in cases
where left-side mounting is not possible, the
Injector Assembly and tubes may be installed
on the other side. Alternate instructions for a
right-side mounting are listed where applicable.
1. Remove the back panel and one of the side
panels from the Taylor C201 mobile cabinet.
2. Remove the adhesive backing from the
foam supports and install one inside each
side support bar inside the Taylor cabinet.
26401
26402
EQUIPMENT SETUP
