Flavor Burst CTP 80BEV-DLX, Operation Manual Supplement

Page: 50 / 54

49
8. Ensure the power-switch is in the “off”
position with the “
○
” end pressed in on the
Electronics Box Power Entrance Module.
9. Connect the Injector Motor Cable to the
round metal port.
NOTE: 80FCB DO NOT HAVE A ROTOR
CABLE CONNECTION.
10. Connect the ethernet cable to the ethernet
port in the plastic gland. Screw the plastic
cover over the connection and secure the
ethernet gland assembly with the nut.
11. Connect the power cord to the port on the
back panel.
12. Use the four screws of the Electronics Box
to mount the box to the back panel of the
Deluxe Cabinet. The Electronics Box needs
to be mounted with the connections at the
bottom, to minimize any damage should it
come in contact with water. Install the
screws through the slotted holes of the
Electronics Box and through the Deluxe
back panel. Secure the screws with the lock
nuts from the inside of the back panel.
13. Install the back panel with Electronics Box
to the back of the Deluxe cabinet using the
two screws provided.
14. Plug the power cord into an outlet near the
cabinet.
26220
26218
26219
26222
26229
26254