Supplied By www.heating spares.co Tel. 0161 620 6677
continue to hold the control knob for a few seconds then turn to the full-
on position.
d)
Check that the gas pressure is
20.0 mbar (+/- 1.0mbar) 8.0 in w.g.(+/-
0.4 in w.g.)
e)
Turn off the fire, remove the manometer and refit the pressure test point
screw. Check the pressure test point screw for gas tightness with the
appliance turned on using a suitable leak detection fluid or detector.
SECTION 3
ASSEMBLING FUEL-BED AND COMMISSIONING
3.1
ASSEMBLING THE FUEL-BED - Coal Fuelbed Model
a)
Place the fuelbed base centrally on to the fuelbed support and push
fully backwards to the rear face of the fibre boards
Make sure that the
fuelbed base is located centrally in the fire box
. See Fig. 10 below.
Fig. 10
16