Action:
(CHASE Review)
1) Press any one of the 6 CHASE buttons.
2) Press the TAP DISPLAY button to view
the step number on the display.
3) Press the BANK UP/DOWN buttons
review all scenes in the chase.
Notes:
Make sure you are still in MANUAL Mode.
———⬤———
Programming
A program (bank) is a sequence of different
scenes (or steps) that will be called up
one after another. In the DMX-240A 30
programs can be created of 8 scenes in each.
ENTERING PROGRAM MODE
1) Press the Program button until the LED
blinks.
CREATE A SCENE
A scene is a static lighting state. Scenes
are stored in banks. There are 30 bank
memories on the controller and each bank
can hold 8 scene memories. The DMX-240A
can save 240 scenes total.
Action:
1) Press the PROGRAM button until the
LED blinks.
2) Position SPEED and FADE TIME sliders
all the way down.
3) Select the SCANNERS you wish to include
in your scene.
4) Compose a look by moving the sliders
and wheel.
5) Tap MIDI/REG button.
6) Choose a BANK (01-30) to change if
necessary.
7) Select a SCENES button to store.
8) Repeat steps 3 through 7 as necessary.
8 scenes can be recorded in a Program.
9) To exit program mode, hold the
PROGRAM button.
Notes:
Deselect Blackout if LED is lit.
You can select more than one fixture.
You can access channels 9~16 by pressing
the Page Select button. This is necessary for
fixtures that use more than 8 channels of
control.
There are 8 scenes available in every bank.
All LEDs will flash to confirm. The LED
display will now indicate the Scene number
and Bank number used.
Tip!
Press the FINE button, activate
joystick or slider by moving it then use the
Bank Up/Down buttons to change values in
increments of „1” .
Shortcut:
Press [P [SCANNERS]
Adjust [Faders & Wheel]+[BANK] +[SCENE]
+Press [PROGRAM] to store.
RUNNING A PROGRAM
Action:
1) Use BANK UP/DOWN buttons to change
Program banks if necessary.
2) Press the AUTO DEL button repeatedly
until the AUTO LED turns on.
3) Adjust the PROGRAM speed via the
SPEED fader and the loop rate via the FADE
TIME fader.
4) Alternatively you can tap the TAP
DISPLAY button twice. The time between
two taps sets the time between SCENES (up
to 10 minutes).
Notes:
Deselect Blackout if LED is lit.
Also called a Tap-Sync.
CHECK PROGRAM
Action:
1) Press and hold the PROGRAM button
until the LED blinks.
240A DMX CONTROLLER 240ch 2019
•
Art No F9000382
