34
INSTALLATION STEPS
Prior to starting the installation, make sure you read and understand all WARNING information in the manual.
Do not start the installation if you are not clear about any of the installation related subjects.
DETERMINE THE FOLLOWING:
•
Clearance requirements from combustible and non-combustible materials. Follow the
clearance instruction
and example
in the manual.
•
Gas supply piping.
•
Confirm if the fireplace is going to operate using Natural Gas (NG) or Propane (LPG). Use the attached
product label to confirm the fireplace is set for the expected gas type.
•
Electrical wiring requirements.
•
Framing and finishing details.
1.
Unpack the fireplace box, adjust telescopic legs and place in the upright position.
Follow instruction for
fireplace unpacking.
2.
Put the Fireplace in the desired location. Verify clearance to non-combustible and combustible materials.
Follow the
clearance instruction
and example in the manual.
3.
Connect gas (
Gas connection section
) line to the Fireplace and verify gas inlet and outlet pressure.
Measure and document gas pressure here:
Inlet _______ W.C.
4.
Confirm if adjustments for
high altitude
are needed (Installation at above 2000 Ft from sea level).
5.
Connect electrical wiring for applicable units.
6.
Insert and place Fireplace media. Use
media arrangement
guide from the manual.
7.
Verification of:
•
Ignition and pilot system.
•
Burning and flame.
8.
Complete framing and wall cover.
READ ALL THE INSTRUCTIONS BEFORE STARTING THE INSTALLATION. FOLLOW THESE INSTRUCTIONS
CAREFULLY DURING THE INSTALLATION TO ENSURE MAXIMUM SAFETY AND BENEFIT. FOLLOW THE STEPS
ABOVE TO INSURE PROPER INSTALLATION OF THE GAS APPLIANCE. WARNING! RISK OF FIRE OR
EXPLOSION! DAMAGED PARTS COULD IMPAIR SAFE OPERATION. DO NOT INSTALL DAMAGED,
INCOMPLETE OR SUBSTITUTE COMPONENTS.
