26 |
P a g e
INSTALLATION STEPS
1.
Prior to starting the installation, make sure you read and understand all WARNING information in the
manual. Do not start the installation if you are unclear about any of the installation related subjects.
2.
Determine the following:
•
The vent system configuration to be used based on the fireplace location. Follow the manual venting
section (
Chimney path installation & planning tables
) to determine the venting requirements and
setting.
Note:
Venting requirements are model specific.
Note:
Make sure the vent requirements are supported by the Flare manual and installation
instruction.
•
Clearance requirements from combustible and non-combustible materials. Follow the
in the manual.
Note: Clearance instructions and examples are model specific.
•
Gas supply piping.
•
Confirm if the fireplace is going to operate using Natural Gas (NG) or Propane. Use the attached
product label to confirm the fireplace is set for the expected gas type.
•
Electrical wiring requirements.
•
Framing and finishing details.
3.
Unpack the fireplace box, adjust telescopic legs and place in the upright position.
4.
Put the Fireplace in the desired location. Verify clearance to non-combustible and combustible materials.
Follow the
and example in the manual.
5.
For LED units, connect LED system and test LED.
6.
Attach the units back bracket to the wall framing.
7.
For double glass units only: remove glass locking screws and discard.
8.
Adjust Fireplace
based on vent configuration and planning guide. Document vent restrictor
setup here: ___________________________.
9.
Connect vent system to the Fireplace.
10.
Connect gas (
) line to the Fireplace and verify gas inlet and outlet pressure. Measure
and document gas pressure here: Inlet _______ W.C.
11.
Confirm if adjustments for
are needed (Installation at above 2000 Ft from sea level).
12.
Connect electrical wiring for applicable units.
13.
Insert and place Fireplace media. Use
14.
Verification of:
•
Ignition and pilot system.
•
Burning and flame.
15.
Complete framing and wall cover.
Read all the instructions before starting the installation. Follow these instructions carefully during the installation to ensure
maximum safety and benefit.
Follow the Steps above to insure proper installation of the Gas appliance.
WARNING! Risk of Fire or Explosion! Damaged parts could impair safe operation. DO NOT install damaged, incomplete or
substitute components.
