11
4. If lag-bolts and anchors are to be used to secure the insert, the hole locations should be marked
with the unit in place. Remove the insert and locate the anchors.
5. Remove the faceplate panels from their box and assemble according to the following
instructions.
2.5 Air control plate, faceplate and fan Assembly Instructions
1.
Place the faceplate panels with the finished side down on a flat, soft, non-abrasive surface.
2.
Assemble the faceplate trim, attaching the mitered corners with the corner brackets.
(see Figure 2.4)
3.
Line up the holes of the side and top panels and secure with the screws, washers and nuts. (see
Figure 2.5a)
4.
Slide the assembled trim over the edges of the faceplate.
5.
Secure trim to faceplate using "U" shaped clips. (see Figure 2.5b)
6.
Fan is already attached to the unit at the factory with two tie straps. Remove the two tie straps
and clip the blower assembly back onto the unit.
Figure 2.4
Figure 2.5a
Figure 2.5b
Figure 2.5c
