1. Short description
2. Hardware / Connections
The "XPANMIX" module is a combination of an XFADER and a PANNING mixer recorder. In the
upper part of the module is the XFADER with two inputs to one output. In the lower part of the
module is the PANNING mixer with one input to two left/right outputs. The inputs are designed
for audio or CV sources in the voltage range of +-5v (audio modular level). In addition, the inputs
can be switched separately to +6db audio (for external audio line level) using the rear slide
switch. The movements of the two mixer controls can be recorded for up to 2 minutes. The play-
back speed can be adjusted in the playback. The recorded track is played once (one shot) by
briefly pressing the Play button or in a loop by pressing it a little longer.
Both mixers have a separate reset and CV input (+-5V) for controlling the mix, e.g. with an LFO.
The track data is stored permanently (battery-buffered memory).
In addition, the XFADER output is routed to the input of the PANNING mixer if no cable is plug-
ged into the PAN input. Both mixers are thus connected one after the other and PAN of the XFA-
DER can also be used for mixing in the stereo image.
3
2.1 Connection to the modular system
(Doepfer bus)
The module is delivered with a connected
ribbon cable for the Doepfer bus. The red
lead marks -12 volt. Connecting the module
please note the right polarity!
If the module is poled accidentally wrong
safety diodes avoid the immediate destruc-
tion of the module but further damages can-
not be excepted.
So please pay attention: Check the connec-
tion various times before switching on!
-12V
Ground
Ground
Ground
+12V
