Floor height calibration
Short press power button to make headset sleep. A second short press wakes the
headset. Whenever you see the spinning image it is important to look down at a clear
floor (e.g. away from tables and chairs) to ensure accurate floor height calibration.
Hose Tracker freezing
The tracker is optically tracked. Avoid blocking line of sight between the headset and
the tracker. Hold the hose instead of the tracker for best results.
Hose Tracker/Right Controller not tracking
If a blue light is displayed on the Controller or Tracker, hold down the power button
until the blue light turns off. Then single press the power button to turn back on. If not
resolved, restart the headset.
Controller not charging
Ensure that you are charging the Right Controller. The Left Controller should not be
used. If using the split cable make sure that the single end is plugged into the power
source and have the controller/tracker plugged into the split cable at the other end.
Alternatively use the USB A to USB C cable.
Charging the VR Headset
Charge the headset by connecting the AC adaptor to a power outlet, and then
connecting it to the headset. Charging the headset while in use is not recommended.
Shutdown
Hold down the power button on the VR headset for 5 seconds.
Volume
To adjust the volume, use the controls on the bottom left-hand side of the VR headset.
Troubleshooting
19
Summary of Contents for Extinguisher V3
Page 11: ...10 ...
