65
Figure 3.5.10 Positioning antenna spacing calibration
Step 1: Create a guidance line: create and import a guidance line. (The
starting point is point A, the end point is point B)
Step 2: Set the line spacing and select the operation mode: set the operation
spacing in the "parameter setting" to 10 meters, and select the operation mode
as multi-line mode.
Step 3: Drive two times.
First driving: Drive the vehicle at a low speed from point A to point B. If the
vehicle is stable (the offset error displayed on the screen is less than 2 cm), stop
after the driving distance is not less than 10 meters, and mark at the right rear
tire position of vehicle, confirm the marking line L1.
Second driving: After marking the marking line L1, turn the vehicle around
and continue driving in the reverse direction along the driving route just now.
When driving to the vicinity of the marking line L1 in the second step (note:
ensure that the driving status is stable at this time, that is, the offset distance
displayed on the screen is less than 2 cm), stop and draw the marking line L2 at
the left rear wheel position.
©FJ Dynamics Technology Co., Ltd. All rights reserved.
