INSTRUCTION MANUAL
Electrical winches LM500+/300S+
Réf : 1813000208
Page :
15/20
Version : 39/21
The hoist does
not lift the
load
The groove pulley is worn or dirty
The capacitor is disconnected or out of
service (for single phase hoist only)
The temperature sensor is activated
Power cable section too thin
The wire rope is inserted in wrong way
Verification
Verification
Wait until it cools
Replace the power cable
Verification
Current
too
high
The brake is out of service
The capacitor is disconnected or out of
service (mono phase hoist only)
The motor is blocked
Verification
Reconnect the capacitor or change it
Verification (maintenance)
Slow slide
The groove pulley is worn or dirty
The brake is worn
The adhesion system is worn or dirty
Verification
Adjust the brake
Verification
3.3
Spare parts
Use only FIXATOR original spare parts.
Note and send the information listed on the plate
shown below before requesting parts.
Main wear parts and estimated replacement
frequency (highly dependent on actual usage) :
Grooved pulley
ref 462001
100h
S/A Travel limit
ref 461022
400h
Pinion shaft
ref 461024
/
Pressure system
ref 461023
500h
Travel end stopper
ref 462030
/
Capacitor 60uF
ref 540144
/
Capacitor 80uF
ref 461036
/
Capacitor 100uF
ref 461037
/
Pendant control
ref 461020
/
Motor cap
ref 462021 /
Fuse
ref 244612
/
3.4
Disposal
Disassembly and disposal of the hoist must be in
accordance with the current regulations in force.
Electrical components, gear oils, greases, etc ...
should be separated and sent to the appropriate
treatment locations.
3.5
Noise emission
The A weighted sound pressure levels at
workstations is less than or equal to 70 dB (A)
4
Apendices
4.1
Optional Overload 300 or 500kg
see the manual 1813000229
4.2
wiring diagrams
Document téléchargé par [email protected] - 2022-03-11 15:38:39
