V-MATE SERIES
Full range bi-amplified Loudspeakers |
Owner’s manual
11
ENGLISH
5) When the external device is identified, the V-MATE emits a sequence of two tones (bup - bup) and your iPhone or iPad
“Devices” menu shows BLUETOOTH (in capital letters). It means that the Apple device is synced with the unit. In this
case, proceed to the connection as explained in step 11.
6) If the loudspeaker display shows “Unconnected”, please repeat steps 4) and 5).
7) If after 3 attempts the display still shows “Unconnected” turn off the unit.
8) Before turning on again your loudspeaker, delete or ignore other bluetooth devices already present on the Apple unit.
Menu “Devices” => blue arrow click “Forget this Device”.
9) Wait for 5 seconds, then power on again your loudspeaker.
10) Repeat the steps 4) and 5).
11) To connect both devices press “not connected” in external device. Once connected, the loudspeaker emits a tone
(beep) and its display shows the message “Connected”.
12) Now you can start to send any signal to your unit through the Bluetooth connection.
For further information about bluetooth
®
tuning with different Os, please check our website www.
fiveo.it, or send an email to: [email protected]
1.5 MASTER SECTION
masTEr
The maSTER knob adjusts the overall volume of main outputs. Use this knob carefully, continuously checking your sound
system output quality.
lImIT lEd
This LED is lit when the the amplifiers are pushed over their limits, and a limiter circuit acts to prevent any damage to the
speakers.
poWEr oN lEd
This LED is lit, together with front panel LED, when the POWER ON switch is pressed to ON .
Before turning ON or OFF the unit, please be sure that MASTER knob is in “-∞” position.
pHoNEs/moNITor ouT
This 6.35mm. (1/4”) stereo unbalanced connector can be used to monitor your V-MATE Master signal. Please note that overall
level will be adjusted by PHONES/MONITOR knob (placed close to MP3 player section) in conjunction with MASTER knob.
You can connect this output to an headphones as well as to any external unit, like a recorder or monitoring speakers.
masTEr ouT
This XLR balanced connector can be used to send the Master signal to an external sound device. Please note that overall
level will be adjusted by MASTER LEVEL knob.
You can connect this output also to external units, like a different sound system which will diffuse your mix in different rooms.
WARNING: Despite its XLR connector do not connect this output to a microphone input!
pHoNEs/moNITor lEVEl
This knob adjusts, in conjunction with MASTER knob, the overall PHONES/MONITOR OUT level.
Please note that this knob is close to MP3 player section.
mp3 bluETooTH
®
lEVEl
This knob adjusts the playback level of the MP3 player or Bluetooth® signal.
Even this knob is located near to the MP3 player.
21
22
20
19
18
17
16
