4/4
This device is intended only for OEM integrators under the following conditions:
1)
The
antenna
must
be
installed
such
that
20
cm
is
maintained
between
the
antenna
and
users,
and
2)
The
transmitter
module
may
not
be
co
‐
located
with
any
other
transmitter
or
antenna.
As
long
as
2
conditions
above
are
met,
further
transmitter
test
will
not
be
required.
However,
the
OEM
integrator
is
still
responsible
for
testing
their
end
‐
product
for
any
additional
compliance
requirements
required
with
this
module
installed
IMPORTANT
NOTE:
In
the
event
that
these
conditions
can
not
be
met
(for
example
certain
laptop
configurations
or
co
‐
location
with
another
transmitter),
then
the
FCC
authorization
is
no
longer
considered
valid
and
the
FCC
ID
can
not
be
used
on
the
final
product.
In
these
circumstances,
the
OEM
integrator
will
be
responsible
for
re
‐
evaluating
the
end
product
(including
the
transmitter)
and
obtaining
a
separate
FCC
authorization.
End
Product
Labeling
This
transmitter
module
is
authorized
only
for
use
in
device
where
the
antenna
may
be
installed
such
that
20
cm
may
be
maintained
between
the
antenna
and
users.
The
final
end
product
must
be
labeled
in
a
visible
area
with
the
following:
“Contains
FCC
ID:
YFXQCA9531”.
The
grantee's
FCC
ID
can
be
used
only
when
all
FCC
compliance
requirements
are
met.
Manual
Information
To
the
End
User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user’s manual of the end product which integrates this module.
The
end
user
manual
shall
include
all
required
regulatory
information/warning
as
show
in
this
manual.
