Step Two
Lock the Roller Hinges (F5-1064) onto the
Table Bed Assembly (FS-1030)
• For ease of assembly, rest the Table Bed
against the side of the A-frame
(Figure 3).
• Open the cam locks on each side of the Table
Bed.
• With the grooved pivot pins facing outward,
insert the Roller Hinges into the brackets on
each side of the Table Bed (Figure 4A). The
Roller Hinges must slide between the cam
locks and the brackets.
• Make sure the Roller Hinges are in the same
hole setting on both sides.
• Push down on the cam locks (Figure 4B) to
secure the hinges. Figure 5 shows the Roller
Hinges engaged correctly (in setting C).
Refer to the Owner’s Manual for an explanation
of the hole settings. If you are unsure, use “C”
to start.
Step Three
Attach the Table Bed Assembly (FS-1030) to the
A-frame (FS-1010)
• Holding each side near the Roller Hinges,
pick up the Table Bed and stand at the front
of the A-frame where the crossbar is located.
Lower each pivot pin into the A-frame hinge
plates at the same time (Figure 6). Figure 7
shows the correct placement of the pivot pin
into the hinge plate.
• Make sure that both pivot pins are seated at
the base of the slot in the hinge plate. Check
to make sure that the self-locking hooks have
closed over both pivot pins (Figure 7), and the
table rotates smoothly.
FitSpine Trainer
6
5
FitSpine Trainer
ASSEMBLY
ASSEMBLY
Step Four
Insert the Main Shaft (FS-1052) into
the Table Bed Assembly (FS-1030)
• With the height adjustment
settings on the
Main Shaft facing up, slide the end of the
Main Shaft into the bushing in the Main Shaft
housing (Figure 8).
• Pull out the height selector locking pin to
allow the Main Shaft to slide in further (Figure
9). For the purpose of easy assembly, slide in
the Main Shaft and release the pin in the last
height setting (Refer to the Owner’s Manual
for proper height adjustment before use).
• The Main Shaft
must rest against the
crossbar of the A-frame (Figure 10). The
crossbar prevents the table from rotating
forward when the user steps on the Foot
Platform. If the Main Shaft does not rest on
the Crossbar as shown in Figure 10, then the
Table Bed has been assembled backwards
onto the A-frame and this must be corrected
before use.
Step Five
Install the Front Foam Rollers (F5-1051)
• Slide the Foam rollers over each side of the
Front Ankle Bar (Figure 11A).
TIP: Rotate the Front Foam Rollers up and
down repeatedly while pushing onto the bar
for easier assembly.
• Insert the black plugs (F5-1056) into each
open end of the Front Ankle Bar if they are not
already assembled (Figure 11B).
Figure 3
Self-Locking
Hook
Pivot Pin
Figure 4A
Figure 4B
Figure 5
Figure 7
Figure 6
Cam Locks
Pivot Pin
A B C
Figure 8
Figure 9
Locking Pin
Figure 10
Crossbar
Figure 11A
Figure 11B
