Figure 14
Showing “Low Setting”
Figure 13
Step One
Assemble the Front Stability Feet (IA-1101)
and Rear Stability Feet (IA-1104) to the
A-frame Base (FS-1010)
• Set the A-Frame so the base
points up
(Figure 1A). This will give you downward
leverage to properly assemble the
Stability Feet. Steady both sides of the
A-frame so the legs do not swing open.
• To attach the Rear Stability Feet (IA-
1104), first determine which is the left
and right foot. Do this by referring to
the grooves inside each of the feet. The
grooves should face outward, toward the
curved corner of the A-Frame (Figure
1A). Insert the screw (IA-1104-S) for
each foot from the base and tighten with
Screwdriver (F5-1033).
• To attach the Front Stability Feet, first
determine which is the right and left
stability foot by the imprinted letters
“R” and “L” on each foot. Place each
foot on the frame so that the letters face
inward towards each other
(Figure 1B).
• Once the Stability Feet are in place, turn
the A-frame over so the Stability Feet are
on the ground. Open the A-frame and
make sure the spreader arms are locked
(Figure 2).
Step Six
Assemble the Rear Bar with Ankle Clamps
(F5-1054)
• With the rounded corners of the rear
foam ankle piece facing down, insert the
rear bar with one ankle clamp into the
large hole at the bottom of the main shaft
(Figure 12A).
• Align the hole in the rear bar with the
hole on the main shaft and insert the Hex
Bolt (F5-1087) into the holes from the
rear. Install the washer and nut; tighten
with the wrenches provided.
• Slip the other foam ankle clamp
(rounded corners down) onto the rear
bar and push the black rubber plug
(F5-1056) into the bar (Figure 12B).
Step Seven
Install the Foot Platform Assembly
• Slide the Foot Bar (IA-1119) with one
pre-assembled side of the Foot Platform
(IA-1118) into the hole beneath the Ankle
Clamps.
• The Foot Platform is designed with a
High and Low setting. Position in the Low
setting (screw holes facing up) for ease of
assembly. Slide the other side of the Foot
Platform onto the Bar (Figure 13).
• Insert the screw (IA-1123) into the Foot
Platform (Figure 14) and tighten with the
screwdriver (F5-1130) provided.
Note: Refer to the Owner’s Manual for a
description of the settings.
FitSpine Trainer
4
7
FitSpine Trainer
ASSEMBLY
ASSEMBLY
(Front)
(Back)
Figure 2
Figure 1A
Figure 1B
Spreader Arms
Grooves
Figure 12A
Figure 12B
