16
ASSEMBLY
Step 7
7a. Installing the Left and Right Front Cover:
Attach the
Left Front Cover (25)
and
Right Front
Cover (26)
onto the
Seat Slide Tube (3)
with two
Self-Drilling Screws (64).
Align the edges of the
covers and
use one
Screw (63)
to secure both covers together. Tighten the hardware using the
Multi Hex Tool
with Phillips Screwdriver
provided.
7b.
Connect the
Lower Hand Pulse Wire (20)
to the
Hand Pulse Extension Wire
Ⅱ
(46)
from the
inside the
Right Rear Cover (31).
7c. Installing the Right and Left Rear Cover:
Attach the
Left Rear Cover (32)
and
Right Rear
Cover (31)
onto the
Seat Slide Tube (3)
with two
Self-Drilling Screws (64).
Align the edges of
the covers and
use three
Screws (63)
to secure both covers together. Tighten the hardware using
the
Multi Hex Tool
with Phillips Screwdriver
provided.
Note: If there are problems aligning the covers, loosening the Seat Slide Tube in step 6 and shift
the Seat Slide Tube as needed. Re-tighten the seat slide tube hardware before finishing the
installation of the covers.
Note: If the covers make noise while riding, slightly loosen the hardware that holds both sides of the
covers together.
Hardware Pack:
(63) Screw
4 PCS
(64) Self-Drilling
Screw 4 PCS
Multi Hex Tool with Phillips
Screwdriver
1PC
Tool:
3
Summary of Contents for X CLASS 410 ST
Page 5: ...3 LABEL PLACEMENT ...
Page 8: ...6 OVERVIEW DRAWING ...
Page 11: ...9 HARDWARE TOOL PACK ...